CISCO DEVICES RUNNING VSTACK ASR1001X UPDATE
CISCO DEVICES RUNNING VSTACK ASR1001X SOFTWARE

Many cache entries, reducing the inactive timeout can reduce this overhead. If a large number of short-lived flows is consuming By default, this timeout is 15 seconds, but this value can be adjusted depending on the type of traffic expected. If a flow has not seen any activity for a specifiedĪmount of time, that flow will be aged out. The cache timeout inactive command also controls the aging behavior of the normal type of cache. When you change the active flow timeout, the new timeout value takes effect immediately. A larger value ensures that long-lived flows are accounted for in a singleįlow record a smaller value results in a shorter delay between starting a new long-lived flow and exporting some data for It can be adjusted according to system requirements. By default, this timeout is 1800 seconds (30 minutes), but This age out process allows the monitoringĪpplication that is receiving the exports to remain up to date. If a flow has been active for a long time, it is usuallyĭesirable to age it out (starting a new flow for any subsequent packets in the flow). The cache timeout active command controls the aging behavior of the normal type of cache. When a flow times out, it is removed from the cache and sent to anyĮxporters that are configured for the corresponding flow monitor. Such as the time that a flow is allowed to remain in it. Each cache has various configurable elements, The following flow cache parameters for a flow monitor are enabled:įlow monitor configuration Command History ReleaseĮach flow monitor has a cache that it uses to store all the flows it monitors. The default flow monitor flow cache parameters are used. The entries in the flow cache will be aged out according to the timeout active seconds and timeout inactive seconds settings. For a permanent flow cache the rangeĬonfigures a normal cache type. The range is 30 to 604800 (7 days) for a normal flow cache.

CISCO DEVICES RUNNING VSTACK ASR1001X UPDATE

Specifies the update timeout for a permanent flow cache.

To remove a flow cache parameter for a flow monitor, use the no form of this command.Ĭache To configure a flow cache parameter for a flow monitor, use the cache command in flow monitor configuration mode. snmp-server enable traps power-ethernet.snmp-server enable traps mac-notification.

CISCO DEVICES RUNNING VSTACK ASR1001X SOFTWARE

show platform software fed switch ip wccp.show parameter-map type subscriber attribute-to-service.monitor capture (interface/control plane).

Cisco devices running vstack asr1001x